Parts list for Saiga 7.62x39 conversion?

Question

I own a Saiga rifle (7.62x39) and would like to convert it to the proper pistol grip configuration. The only other answer to this question that I turned up from searching was about 922r compliance. I already have the Tapco T6 stock installed in the out-of-the-box setup on this rifle, as well as an American-made magazine, so I'm not worried about the compliance (5 parts already).

What I need to know is what are the new parts needed for this conversion? I need to finish it within the next month and need to know what to order online. I'm not worried about doing the mag conversion just yet; I'll get to that later. I don't have a huge budget either, but I only have access to some of the needed tools for the next month. From what I've read, apparently I'll need the Tapco G2 trigger kit, single hook I believe? And a drill bit for drilling metal (one I read used a cobalt bit), but I don't know what size to get.

What are the special tools I'll need (I have access to a dremel and 1/2" drill) like drill bits, rivet press, etc?
What are the parts I need to install on the rifle, and which can I reuse?

Answer 1

Maybe this would help.......



http://www.cross-conn.com/Saiga_Conversion/



http://www.youtube.com/watch?v=XU96VbnSoTc



http://home.comcast.net/~navy87guy/home/saigaconversion.html



http://forum.saiga-12.com/



http://vimeo.com/2787027

Answer 2

Saiga 7.62x39 Conversion

Answer 3

Why do you need a good trigger pull on a shotgun? You squeeze a trigger on a rifle and pull the trigger on a shotgun.